2. Proper installation in accordance with the instructions provided with the appliance and in accordance with all local electrical codes. 3. Proper connection to a grounded power supply of sufficient voltage, replacement of blown fuses, repair of loose connections or defects in house wiring. 4. The appliance must be operated in a clean open area that has plenty of airflow and is not above 95°F (35°C) or below 35° F (2°C). 5. Damages to the appliance during or after installation. Do not lift the unit by holding onto the door. seis. Properly maintaining and operating the freeze dryer and vacuum pump. 7. Ensuring freeze-dried food, or other freeze-dried material, are completely dry prior to packaging. 8. Ensuring proper, durable containers are used. Containers, once sealed, must not allow water or air to penetrate them. nove. Ensuring sufficient/proper, fresh oxygen absorbers are included in the sealed container with the freeze dried material. They must not have expired or been exposed to the air prematurely for too long of a time. Harvest Right accepts pelo responsibility for the quality of freeze-dried food or freeze-dried materials; nor does it accept responsibility for the packaging of the food or other freeze-dried material. Exclusions: 1. Any modifications or add-on after-market accessories will void the warranty in its entirety. 2. Consequential or incidental damages such as, but not limited to, property damage and incidental expenses resulting from any breach of this written or any implied warranty. 3. Service calls which do not involve malfunction or defects in workmanship or material. 4. Damages caused by services performed by persons other than authorized by Harvest Right. 5. Parts other than Harvest Right repair parts or parts obtained from suppliers other than Harvest Right personnel. seis. External causes such as abuse, misuse, inadequate power supply, or acts of God. 7. Products with original serial numbers that have been removed or altered and cannot be readily determined. 8. Using an extension cord instead of direct line connection to available power supply. 9. Claims for personal injuries, incidental or consequential damages, or economic loss (profit or revenue), however caused. 10. If you are not the original owner of the freeze dryer, the warranty no longer applies. Service: Since it is the responsibility of the consumer to establish the warranty period by verifying the original purchase date, keep your delivery slip or purchase receipt or some other appropriate payment record. This written warranty gives you specific legal rights. You may have other rights that vary from state to state. Click here for more details: Read our Return Policy
I honestly think putting a thermometer inside the unit is an excellent idea. I sent the following note off to Harvest Right Support in an effort to gain a little better understanding of the process.
I think a community-built troubleshooting manual is a great idea. These machines are simple in some ways, and more complex in others, and having a lot of eyes on the problem is always good.
I sent Harvest Right a note with a picture and they immediately shipped me a new display. Great Service again from the support team there! I think water had dripped down the front and the back of the unit and onto the display card shorting it out.
The one "gotcha" I encountered in making this is that a typical car oil filter attaches with a 3/4x16tpi threaded pipe. I could find pelo such pipe anywhere. My solution was to use instead a 3/4x16tpi bolt, and then drill a hole through it.
Crispness is a hallmark of a good pickled vegetable. That crispness comes from the vegetable’s conterraneo pectin.
Installation of unit. This appliance cannot sit on the floor: both because it must be elevated for the ice melt tubing to drain into a container below it, and to be able to access the vacuum pump and the on/off switches for the unit.
nove) The last port to insulate required the top be removed. Before I removed the top cover I replaced the side covers. This keeps the back and front panels structurally rigid. Do not remove both the side panels and top or you will have problems reassembling as things get very loose.
The evaporator coils that touch the surface of the stainless steel vacuum chamber reach about -42 F. With food in the chamber and because the location of the thermister is on the middle shelf of the four shelves, the temperature it records is going to range from -25 to -30 F in the nove hour default freeze time. This temperature is very adequate for freeze drying the food.
Canned foods can either be purchased commercially or home canned. Home canned foods should be canned using research-tested recipes and processes like those found in the USDA Complete Guide to Canning or in Extension publications.
After buying our freeze dryer I was naturally curious as to how it "knew" when something was done, since batch times varied so much depending on what was being processed. Watching the cycle times didn't seem to tell me anything at first -- especially without a thermometer to tell me what more info was happening inside -- until I finally caught on that applying heat to the frozen food affected the vacuum, which provided the measure of how dry the food had become.
We have to face one hard fact when shopping for home freeze dryers. That fact is, unlike many other purchases, freeze dryers aren't cheap. However, unlike many other purchases, a freeze dryer can provide a lifetime of cost savings that ultimately pay for itself.
It would also be best to avoid pawn shops. Although they can be a goldmine for trinkets, they’re usually not a great place to shop for advanced machinery.
Most pharmaceutical or laboratory-grade freeze-dryers have to be purchased from licensed manufacturers. These sales often need to be done over the phone or in person with an equipment salesman, though those can be found online. Some options are also available online at places like Amazon.